Interfaces

•PCI-104

• According to the specification requirements, the board has installed PCI-104 connector designed for the further extension of functionalities

•RS-232/485/482

• Independent selection of active interface on each of the ports

• 2x interface ports are routed to IDC2-10 connectors

• Insulation 500 W

•1-wire

• Switching between 1-wire and RS-232/485/422 is made via board jumper

•SATA interface

• Transfer rate is determined by CPU module

• 7xpin connector for a drive with SATADOM form-factor support

• SATA channel can be switched from the module to stack

•Connector for Mini PCIe card

• Installation of peripheral devices in mini PCIExpress card form-factor (rev. 1.2 compliant)

• Signals of WLAN#, WPAN#, WWAN# LEDs arerouted to a separate connector of the board

• SIM-cards can use external connectors and can be installed into board slots;

• Using jumper makes it possible to switch Mini PCIe ports not used by USB-device into the stack

Supported OS

•WinXP Embedded •Linux 2.6

Mechanical

•Resistance to multiple shocks: 50g

•Resistance to vibration: 25g

•Dimensions: 96,1×90,4×22,2 mm

•MTBF: 100 000 hours

Power

•Supply voltage: +5 V (rated consumption – 4.2 A, peak consumption: – 7 A, taking into account the maximum rated consumption of two Mini PCI-Express modules

•Internal power consumption is no more than 1W

•Internal power consumption within the circuit: +5 W, no more than 0.2 A

Environmental

•Operating temperature range: –40°C to +85°C